The CS-D508 can power 2-phase NEMA 14, 17, 23, and 24 stepper motors with incremental encoders. Compared with traditional open loop stepper systems, a CS-D508 adopted closed loop step system can eliminate potential loss of step, make real-time position error correction, and do not need torque reservation (100% torque implementation). Also it can power the driven stepper motor with reduced heating, lower noise, low vibration…
Modell:
CS-D508
Phase:
2
Controll:
Step-dir, CW and CCW
Maximum step frequeny:
200 KHz
Power source:
20 - 50 VDC
Recomended power source:
24 - 48 VDC
Szoftver Cofig. Microstep range:
200 - 512 000
A DIP switch Microstep configurations:
16.
DIP switch Microstep settings:
800, 1600, 3200, 6400, 12800, 25600, 51200, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 40000
Software Cofig. current range:
0,5 - 8,0 A (default 6,0 A)
DIP switch functions:
Microstep, motor direction,, automatic calibration, impulse mode, impulse edge.
Logic current range:
7-16 mA (typical 10mA)
Logic voltage range:
0-0,5 VDC impulse active low, or 4,5-5 VDC impulse active high
Communication type:
RS232 for setup
Impulse enable:
faling edge
Software Config:
0 - 100%
Digital inputs:
3
Digital outputs:
Error output or brake controll or position output
Step leight:
2,5 us (at dutycycle = 50%)
Minimum direction set time:
5 minket
Protection:
Over current; over voltage; chip error; motor cable error; ROM error; automatic setup error;
Isolation resistance:
500 Mohm
Environment:
Avoid dust and oil mist
Operating Environment:
0-50 ° C
Páratartalom:
40 - 95% relatív páratartalom
Vibration:
5,9 m / s2 Max
Storage Temperature:
-20-65 ° C
Mechanical:
116 * 69,2 * 26,5 mm
Weight:
280g
