![]() |
Visit our web shop! |
The CS-D508 can power 2-phase NEMA 14, 17, 23, and 24 stepper motors with incremental encoders.
Compared with
traditional open loop stepper systems, a CS-D508 adopted closed loop step system can eliminate potential loss of step, make real-time position error correction, and do not need torque reservation (100% torque implementation).
Also it can
power the driven stepper motor with reduced heating, lower noise, low vibration…
Modell: |
CS-D508 |
Phase: |
2 |
Controll: |
Step-dir, CW and CCW |
Maximum step frequeny: |
200 KHz |
Power source: |
20 - 50 VDC |
Recomended power source: |
24 - 48 VDC |
Szoftver Cofig. Microstep range: |
200 - 512 000 |
A DIP switch Microstep configurations: |
16. |
DIP switch Microstep settings: |
800, 1600, 3200, 6400, 12800, 25600, 51200, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 40000 |
Software Cofig. current range: |
0,5 - 8,0 A (default 6,0 A) |
DIP switch functions: |
Microstep, motor direction,, automatic calibration, impulse mode, impulse edge. |
Logic current range: |
7-16 mA (typical 10mA) |
Logic voltage range: |
0-0,5 VDC impulse active low, or 4,5-5 VDC impulse active high |
Communication type: |
RS232 for setup |
Impulse enable: |
faling edge |
Software Config: |
0 - 100% |
Digital inputs: |
3 |
Digital outputs: |
Error output or brake controll or position output |
Step leight: |
2,5 us (at dutycycle = 50%) |
Minimum direction set time: |
5 minket |
Protection: |
Over current; over voltage; chip error; motor cable error; ROM error; automatic setup error; |
Isolation resistance: |
500 Mohm |
Environment: |
Avoid dust and oil mist |
Operating Environment: |
0-50 ° C |
Páratartalom: |
40 - 95% relatív páratartalom |
Vibration: |
5,9 m / s2 Max |
Storage Temperature: |
-20-65 ° C |
Mechanical: |
116 * 69,2 * 26,5 mm |
Weight: |
280g |